Explore Our Products

Low Carbon / Mild Steel Strips

Low carbon steels contain up to 0.30% C. The largest category of this class of steel is flat rolled products (sheet or strip), usually in the cold rolled & annealed condition.

The following table will show the specifications of steel we can offer off the shelf:

Applications Gallery

Material Specifications

Category	Specification	Grade	C	Mn	S	P	Tensile (Kgf/mm²)	Elong. (%) min
Ordinary	IS:513-1986	O	0.15	0.60	0.055	0.055	-	-
Drawing	IS:513-1986	D	0.12	0.50	0.040	0.040	28-42	28
Drawing	BS:1449/Part-1/1983	CR-4	0.12	0.60	0.050	0.050	29 min.	-
Drawing	JIS:G-3141/1977	SPCC	0.12	0.50	0.045	0.040	28 min.	32(b)
Drawing	DIN:1623/Part-1/1983	St12	0.10	-	-	-	28-42	28(d)
Deep Drawing	IS: 513/1986	DD	0.10	0.45	0.035	0.035	28-38	32
Deep Drawing	BS:1449/Part-1/1983	CR-3	0.19	0.50	0.040	0.040	20 min.	25(c)
Deep Drawing	JIS:G-3141 / 1977	SPCD	0.10	0.45	0.035	0.035	28 min.	34.41(b)
Deep Drawing	DIN:1623/Part-1/1983	RRSt13	0.10	-	-	-	28-38	34(d)
Extra Deep Drawing	IS:513/1986	EDD	0.08	0.40	0.030	0.030	28-36	36
Extra Deep Drawing	BS:1449/Part-1/1983	CR-2	0.08	0.45	0.035	0.030	29 min	27(c)
Extra Deep Drawing	JIS:G-3141/1977	SPCE	0.08	0.40	0.030	0.030	28 min	36.43(b)
Extra Deep Drawing	DIN:1623/Part-1/1983	RRSt-14	0.08	-	-	-	28-36	38(d)
Non-Ageing Extra Deep Drawing	BS:1449/Part-1/1983	CR-1	0.08	0.45	0.030	0.025	29 min.	29(c)

Range

Thickness Range	0.07 mm to 5.00 mm
Width Range	4 mm min to 1800 mm max
Hardness	As per customer requirement
Available Tempers	Dead soft material (max 90 VPN), Soft/annealed, Quarter hard, Half hard, Full hard